Your Cart
Search used machines
CASANOVA
Section bender Casanova FC.1
- Control
- Yes, with levers
Fresh stock comes in every week and we work with a network of suppliers across Europe. Tell us what you need and we will find you the same machine or a similar one.
We reply within 24 working hours.
Technical data sheet
General data
| Mobile control pendant | Yes, with levers |
|---|
Data from our purchase record, subject to verification. Please confirm any important figure with us before purchase or come and see the machine.
Description and equipment
Casanova FC-1 section bender
Three-roll section bender for bending tube, angle, flat bar and other cold-rolled sections. The machine plate states type FC-1 and the Casanova brand.
Model features
According to the manufacturer's catalogue sheet (FC series, no serial no., not attributed to this unit), the FC-01 model is stated to have fully hydraulic drive with overload protection and a 3 HP hydraulic power unit, with a working speed of 4.5 m/min and 60 mm diameter shafts.
For the FC-01 the catalogue gives standard rolls of 160 mm diameter; this is a catalogue figure, not measured on this unit. The catalogue shows the FC-01 without a remote control console, whereas this unit has one, so the catalogue should be taken as a guide only.
Configuration of this unit
- Three rolls and lever controls on a mobile console with wheels.
- Two dial gauges on the top.
- Worn paintwork with rusty areas on the housing; the actual condition cannot be assessed from the photos.
- Plate: type FC-1, Casanova brand.
Typical applications
Making rings, arches and structures from tube, angle, flat bar and other sections: metal fabrication, railings, structures, staircases and metal furniture.
See it at Ferrotall
The machine is at our premises in Monforte del Cid (Alicante), where you can visit it; contact us to see it running or to receive a video. Our own service engineers take care of transport, installation and commissioning.
Frequently asked questions
What is a three-roll section bender?
It is a machine that bends sections by passing them between three rolls: two support rolls and one that presses and sets the radius. According to the manufacturer's catalogue sheet, models FC-01 to FC-05 can work in both the horizontal and vertical positions. It is used to bend tube, angle and flat bar with rolls suited to each section.
Can the rolls be changed for different sections?
On this type of bender the rolls are changed to suit the section. Which rolls are supplied with this unit is not recorded in the data sheet, and we do not assume any additional set is included; we will confirm this before quoting, so you know which sections you can bend straight away.
Visit, transport and commissioning
- See it running Visit it at our facilities or ask us for a video of the machine under power.
- Transport We handle dismantling, loading and transport to your workshop.
- Commissioning Installation, levelling and commissioning by our service engineers.
- More than 45 years Used machinery trading backed by our service engineers.
If we don't have it, we'll find it
Section bender Casanova FC.1 · Ref. 016013
Tell us what you need. We search our stock, upcoming arrivals and our supplier network across Europe.